Separate names with a comma.
Cheers Darkman. Will check sizes from boxes tomorrow.
Hi all. I have my 73 t140v bonnie running rich lower speeds and lean higher speeds. I feel as though there just isn’t the power there that should...
Thanks again dude. :)
Ok will try that tomorrow. I read somewhere about boiling the plates?
I seen that advertised. Can feel it slip when revs are high. My old man took the bike out a blast the other day and said it shud be pulling alot...
I have a Tony Hayward conversion?
Cheers darkman. Any particular make best?
Hi all. My clutch is slipping on my 73 t140v bonnie. Been told to get new clutch plates, pads and springs. It has a belt drive kit conversion. Is...
Hi folks. Got to the bottom of the problem. Timing was out. Sorted that then set the carbs. Right carb was alot more responsive while adjusting...
Someone mentioned intake valve?? What should the valves be set at? Been told 1 thou?
Float levels are exactly the same both sides. This is the third carb (original amal, new wassel, replacement wassel) I will check the levels again...
Was the right one, and its still right side thats not running right. It seems that when i shut off the fuel it runs better, then have to put fuel...
Album