Recent Content by Philippe800xr

Here is the original leads and connectors finished to the Tuff Light. The End.

Step 31, Enlarge the forward hole that the wires passed through just enough that LED post fits through.

Step 36, Nice!

Step 33, Here is a view with the adapter plate and no holes visible and a tidy look.

Step 34, Note LED orientation is in line with adapter as I indicated in earlier picture of stock indicator.

Step 35, Note LED orientation is in line with adapter as I indicated in earlier picture of stock indicator.

Step 38, Push in till flush.

Step 32, Fasten LED light with supplied flange nut.

Step 37, Reverse tank panel disassembly order when putting panels back on and pull push rivet center post back out to install position.

Step 29, I elected to solder the stock wires to the new LEDs. I cut off about half of the LED wires. This still left plenty of wire to work with. Brown LED wire is soldered to the white lead and...

Step 25, Place terminal crimp connectors in signal housings, reassemble and save for spares.

Step 27, Enlarge hole in adapter until LED post easily threads itself all the way down.