Yes that's the relay. On some models (with only 2 wires) an additional earth wire is needed but I would think yours will already be wired in to the connector.
^^^ Thank you Col I am petrified when it comes to electrics :-( I just hope it's a plug n play n I don't have to mess about splicing anything
Bike is coming together nicely. Hopefully this Friday I'll be able to post some pics of my pride and joy
Nice PM mate. At the rate you are sending me through I'm not going to be left with any money for the fuel :-(
Ok here we go people. ...got my indicators in today I need to drill number plate bracket hole a little bigger to feed the wire n connector through. As for the relay I thought it was meant to be a plug and play BUT I'm looking at connectors n wires. Beginning of my headache. Those indicators looks quality n sweet
I haven't a clue. Let me check the instructions. ..I think that would be helpful; -) I will 1st start off with drilling the hole to ensure I can the wire through the number plate bracket. Then I shall look into the relay
If you've got standard number plate hanger shouldn't need to do any drilling. Can feed each connector through staggered one at a time.
I have an aftermarket one (tail tidy). I tested the indicators with relay n all good . Im soooooo chuffed Tonight installed mid engine r&gs n engine sliders on both side. The haynes manual engine mounts torque figures are 60 Nm something but I went with R&Gs recommended torquefigure of 40Nm. I just hope I did the right thing. I have installed the front indicators, the rear will be done tomorrow once I managed to drill the brackets. Also light tint headlight covers were installed now . Tomorrow job: HealTech brake light modulator. I just need to figure out brake light switch wire. Then install the rear indicators and red clutch guide. I know. ...I think I lost the plot . All coming together Friday I'll be uploading the photos; -)
^^ I thought it will make the mad London drivers aware of my presence . I'm beginning to think it might not be a good idea with the brake module . Maybe I should cut my postage loss n send it back.
Seems like a lot of money for a flashing lights. Not that I understand how it completely works but say driver behind you is in traffic and playing on their phone as they often do and they see the light flash may they nudge forward thinking your moving
Does the modulator flash briefly for a couple of seconds (or less) then stay on like normal ? The motordynamic combined LED / TAIL lights do this (is it UK compliant) ? You see it in the states I like it personally even if the driver on the phone doesn't Would prefer one that calls out "Oi C..T GET OFF THE EFFING PHONE IM BREAKING" !!