Just fitted a set of Triumph rear LED indicators. I have done the "i" button TYPE reset and the indicators blink at the correct speed. However, if i press the hazard light button they all flash for a split second then won't work at all including the indicator function. The indicators will work again after the "i" button reset, but the hazard light switch will trip it all again. Any help appreciated!
Funnily enough I stopped my Street Cup this afternoon to help a biker-down, and switched on my hazards. Or at least I thought I did. But just the left one worked, even after several attempts. Mine are LED too. Trip to the dealer coming up I think.
Ah, I don't think the engine was running so that might be something to look at. It's going in for its 12 month service at the weekend so asked them to have a check on this as well. Thanks for the posts!
Hi guys, Any updates on what the issue was? Just bought a 2017 Street twin with the same issue. Any help appreciated.
It's a bit like when you were little and said "Dad, my arm hurts when I lift it up" and he would say "Don't lift it up then!"
I recall reading something about this a couple of years ago whilst fitting leds to my ST. It suggested this was due to mixing leds and filament bulbs in the same circuit. They will work independently but not together
Thanks for that - sounds about right - I was going to get the LEDs for the front but I guess I'll have to get them sooner
