Stand Clash

I noticed recently that the side stand is difficult to deploy whilst sat on the bike.
Further investigation shows that the side stand is interfering with the centre stand (or vice versa), by that i mean that when the side stand is pushed out, the end rubs against the frame of the center stand, it doesn't look to be much but makes it very difficult to push the side stand out

I'm sure this didn't happen when it was first fitted?!

Also doesn't look like there is any adjustment to be had on either, they just bolt to the frame in the fixed places

 

nothing looks obviously bent or loose ....

Ps its a TEC stand

 

Just been out and had another look, certainly nothing obviously bent.

Although when i look at how the stand is attached to the frame it is to the left of both of the frame lugs when viewed from the rear. by that i mean the lug on the stand is on the outside of the frame lug (side stand side) and the lug on the stand is on the inside of the frame lug (on the brake pedal side) cant find any info online to suggest whether or not that is correct :s

It does look like someone else had a similar problem:

 

Guess i'll just have to grind the tip off the side stand

 

Well, I finally got round to sorting this sucker out, 8 months later.

Got myself a metal grinder and took a few mm off the end, filed it smooth by hand and finished with hammerite 'hammered finish' gloss black on the whole stand for good measure.

Looks pretty tidy to me