when I purchased my speed, a 2009 model the clutch cable was shredded just above the radiator at a bracket it runs through. There is nothing to secure it on mine so I have stuck a couple of ties on at the minute with a new cable. It seems to require pulled tight from the engine to this point otherwise it slips back and forth over the bracket when you turn the bars side to side. If its secured tight at this point with all the slack pulled to that point it slides back and forth in front of the yoke. Can somebody have a look at theirs and see what mounts it at that bracket above the radiator and perhaps the proper run for it, the photos on the web cant show this. Also is there an obd11 diagnostic plug on the bike somewhere I have a diagnostic tester and it would be nice to check it out, just for fun at this minute but I can also check the stored mileage etc. All the best folk, Dave.