ABS light on after disc change.

Eternal Noob · Apr 26, 2016

Greetings one and all.
I have recently put new discs and pads on my ST1050. However the ABS light now stays on. The only thing I did to the sensor was clean the road dirt off. The sensor ring is the same. Can a slight fluctuation in the thickness of the rotor make a difference? Any suggestions welcomed.

thebiglad · Apr 26, 2016

Hi EN, re the ABS issue: it certainly can make a difference if the distance between the ring and the sensor are out of tolerance.

Make sure any/all wheel spacers are correctly installed before you go any further. Also check that the sensor is correctly seated and the wiring is intact.

Eternal Noob · Apr 26, 2016

Thank you big lad, does anyone know what the tolerance is?

Eternal Noob · May 6, 2016

Issue sorted, apparently there are different thickness shims available. I just used a couple of washers, ABS light out and it works.

Forums

ABS light on after disc change.

Eternal Noob Member

thebiglad Old fart, still riding !

Eternal Noob Member

Eternal Noob Member

2016 Street Triple Abs & Em Lights On

Abs Light On

2012 1050 Abs Headlights

Abs Light Doesn't Turn Off

Engine Management Light Abs Traction Control

Share This Page

Useful Searches

ABS light on after disc change.

Eternal Noob Member

thebiglad Old fart, still riding !

Eternal Noob Member

Eternal Noob Member

2016 Street Triple Abs & Em Lights On

Abs Light On

2012 1050 Abs Headlights

Abs Light Doesn't Turn Off

Engine Management Light Abs Traction Control

Share This Page