Turning The Bike 180 Degrees

@Stu9000 No my sprint was easy to lift on the centre stand It all depends on the room you have to man handle it.

 

I made my own turntable with a 'lazy Susan' from eBay and square steel plates top and bottom, large (around 300mm diameter) last Susans usually have a load capacity more than enough to take a GT1050.
The other way is to buy a square of heavy duty plastic which is normally smooth enough to allow the stand to slide around on it, I don't know how much strain this puts on the stand and I prefer the turntable.

You can also buy a ready made turntable

 

Hi Stu, If you are going this way just check the load capacity of the turntable. There are some mamby pamby ones on eBay for table centres.
You need a heavy duty one of about 300mm dia. with a load capacity of 1,000lbs/450kg.

 

Mine - using two sheets of heavy duty ply. There's a pin in one corner to lock it into place.

Edit.. Only thing to be aware of is it's very hard to get it onto the centre stand due to the extra height. You may need to ride the back wheel up onto a plinth of similar height to the turntable.

 

This guy is always showing off his method. Looks doable with a little practice ...

https://www.youtube.com/shorts/NvXe9BvfwrU

 

Gosh!!! No thanks not for me! I think I'll stick to the turntable!! I wonder how long before the side stand or the lug where it attaches to the frame cries enough!!

 

What about the jack in a box type lifts with wheels on?
You might have to modify the top face so the bike sits nicely, but it onlys needs to lift the tyres just off the floor.

I have one ( without wheels) which I use for off road bikes but just check the load rating.

Something like this, and you could always use a battery drill to operate it, but grease the thread mechanism well. The benefit here is it takes very little space when not in use.

https://www.ebay.co.uk/itm/40521432...yEQKC&var=&widget_ver=artemis&media=WHATS_APP

 

This type of lift is probably ideal if you have a high pipe, duplex cradle frame but, one word of caution/advice around using this type of lift - don't be tempted to use it if the bike's exhaust pipe(s) sit (s) on the lift platform. I know it sounds obvious, but I've actually seen it done. The bike should never have any lift placed beneath the exhaust pipes - even briefly - or you risk bending the pipes or distorting the head ports. If the bikes pipe(s) are lower than the frame rails (or sump on a non-cradle frame) then you may need to block spacer the platform which might mean a less than stable arrangement.

 

Just as a thought. How far is it down past the wall between the wall and car. Is it worth getting off and pushing it in backwards negating the need to construct something to turn it around?
I push my bikes in backwards into my bike shed... stand over the front wheel, legs either side of the front wheel. Push on the handlebars a la tight sales showroom manoeuvres.
Have a look at this vid to see what i am poorly explaining