2004 Bonneville T100 - Curious Problem, Need Your Help!

hey guys,

my name is Fritz, a litte over 30 years old, enthusiastic about motorcycles, i have quite some bikes from the 70s up to 2000s in my possession. I like to wrench on my own or with friends.

problem child: Bonneville T100, 2004, 790ccm, 25tkm, at the moment completly orginal with restrictor plate, intake snorkel... carb jetting is also orginal !

The Triumph was handed over to a Triumph workshop by the previous owner - she no longer wanted to start

Triumph checked the wiring harness in a comprehensible manner and replaced the crankshaft sensor, control unit, ignition coil and spark plugs with new parts. In addition she got a service.
Of course that cost a lot of money. After that she started again.

Now comes the big but: At around 130kmh, it feels like she runs into the limiter ("early"), accelerating above 130kmh is not possible. If you drop the rpm a little you can accelerate up to 130kmh again, that's it. The whole thing is fully replicable. Otherwise it pulls through no dropouts, cut outs, hesitation etc.

Until now i have done the following:
crankshaft sensor measured (approx. 600 ohms) - fits
crankshaft sensor distance checked with feeler gauge (0.85mm) - fits (fully within range/spec)
side stand switch bridged - no change, error remains
tps sensor disconnected - no change, error remains
carburettors disassembled - everything is fine, everything is originally equipped, the float level is correct - no action required
tank ventilation is also OK. and fuel flow is fine too.
air filter box (see above) also original with restrictor plate and intake snorkel etc., air filter also great

I'm currently running out of ideas as to how the error could occur. All components are new (ignition side) and also
original Triumph parts that match my modelyear. In my opinion, the fuel and air side is also perfectly fine.

Maybe you guys have an idea? Could the new control unit simply be faulty ? Am I missing something?

Restrictors of any kind are not installed, i should probably mention that

Would be awesome if somebody could help !

Cheers
Fritz

 

Nope never.
The previous owner was sure, that it only happend after the repairs.

EDIT: I added a tachometer (inductive-just wrapped around the sparkwire) in order to check the rpm at which the cutout happens, and its not only 5th gear but also 1-4 incl. neutral !!! The cutout happens always between 4800rpm-5200rpm in every gear.

regarding restrictors. I even called triumph and asked if there was a igniter (CDI) with a lower rev limiter, but there isnt!

any ideas ?

 

i replaced the brand new orginal triumph ecu with an aftermarket one and the problem was gone !