Rear Hub Question

I have just disassembled the whole rear to regrease the swingarm, drop link and rear hub needle bearings. Everything went fine, I followed the workshop manuals and torqued everything as required.

Bike is Speed Triple R 2016.

My question

Is it normal to have a small of side to side movement between the rear axle and the swingarm/eccentric hub. The bike is jacked up with rear wheel off the ground. If I stand side on and grab the rear wheel with both hands I can feel a small amount of movement when pushing and pulling. There is no play between the wheel, axle, or cush drive hub.

 

A bit of googling shows this to be a common issue. Play at 12/6 oclock but nothing at 3/9. It is not the swingarm adjuster I torqued this correctly to 6Nm and there is no play.

I've been looking at the exploded parts diagram and think I've found the problem. I put together as disassembled but there is a washer 40*46.5*1.6 to go between the cush drive and axle which was placed behind the belleville washer. There should be a flanged sleeve here but it is missing.

Can someone confirm orientation of the flanged sleeve? Looks like a tophat presume the flat side goes against cush drive bearing and narrow side fits into the concave side of belleville washer.

 

Solved

The washer was missing between hub and cush drive. Also the stepped washer was there it just stayed put in the hub when I removed it.

For anyone with similar symptoms about 0.5 to 1mm play at 12/6 oclock but no play at 3 and 9.