Sprint GT 2010 Sprint Gt 1050 No Start!

Could be anything from a bad clutch switch, or the main starter relay.
As a start I would remove the seat and try to listen if the main relay near the battery clic. then I would listen to the starter relay (on a ST 1050 on right side, under the fairing, on a GT I don't know). then switch for another relay to check.

The circuitry is as follow: starter button, safety switches, if ok ECU send a + to the starter relay, the starter relay activate the main relay to send direct power from the battery to the starter motor.

Hope this helps

 

Do you have the datatool alarm?

My ST has shown similar symptoms in the past due to the alarm.

 

You can try to switch with the Main Beam realy. It's the only other one with 5 pins on the bike.
But first check with someone that can put a finger on the relay if it "clics" as you press the start button. (sorry if I don't use the correct words, english is not my language). If the starter relay clics, do the same check with the solenoid relay near the battery. If both "clics" they are not the issue, you'll have to look around the starter motor.

 

Umelo
Welcome to the family. Yes listen for the switches kicking in. Get someone to help by pressing the start when you listen. The solenoid you can test by just putting something across the terminals. That side stand switch is a beggar as well you can test it by joining the two wires. Lastly the clutch switch at the lever is also a menace make sure it pushed in properly and operating I had that on my sprint spent a day looking then saw it dislodged.. These problems are the tricky ones and make you tear your hair out. Also make sure the that the battery is fully charged and not lost any cells and the wires are corrosion free both ends and tight. And check those fuses again and remember it may look good but that doesn't mean its not blown. Wish you luck. Tell you what just send me the ticket and I'll pop over and have a look.
Joe.

 

Hi and welcome

 

I seem to remember something about if the headlight bulb is blown, it won't let the bike start?
Absolutely no idea what bike that was for but worth a look?
You can even check that at night!!!

 

My clutch switch occasionally sticks and the bike does nothing when the starter is pressed. If you're hearing nothing, my money would be on the clutch or side stand switches

Operating the clutch a few times clears the issue. Another one to add to my list of winter jobs ...

 

I was wondering if on the Sprint ST/GT we can bypass the clutch switch without any trouble for the ECU functioning?

 

Hi, bit late to the thread but did you get sorted? I’ve got a similar thing checked relays swapped battery had side off so many times but sometimes it fires and sometimes it doesn’t . Headlights dim so that relay is working and sometimes the starter one clicks and fires and sometimes it doesn’t. Usually goes on 2nd or 3rd press but sometimes its over 10 .

 

Hi Tim

If your headlight are cut off when you hit the starter, that would suggest the starter relay is working fine and the likely culprit is the main solenoid that delivers power to the starter motor

 

Thank you, new one in order but as usual after a day of fettling and spending money it’s been faultless all day - except Lh heated grip now not working and reading many kilo ohms so a second order just gone in