Scrambler Street Scrambler Decat - How Quickly...

Next time you're bored, why don't you take of the decat and sell it to me at a knock down price over on that 'other forum'

 

de catting the high piped bikes is simples, my Scrambler 1200 took half an hour, even with Triumphs passion for no two fixings are the same type, bloody, hex's, torx's bolts screws all different, anyhow. Low exhausts different kettle of anchovies, took like three hours on my Street Twin, mind you on the Street Twin my nuts are not gently baked on each ride.

 

I did mine two weeks ago. 2020 Street Scrambler.
I was hoping to only have to cut one end off and remove the cat but that was not the case. The factory welds got into the cat at both weld locations and needed to be cut from both to remove. Took a good bit of effort to remove. About 20 minutes of prying and banging. After grinding the joints parallel, I TIG'd them back together. Total time was about an hour and half including dis/reassembly. Definitely sounds throaty compared to before. Not sure on the heat generated at the cat location or power improvement yet.