Data tool alarm problems

When alarm is put in service/diagnostic mode the count of alarm led will tell you what is triggering your alarm this is a feature of this type of alarm system it is possible that you have removed seat of bike and have broken the seat micro switch lever.

 

No cutting the loom Peter, simply un clip the plug and socket that joins the Datatool into the loom and bridge 4 specific terminals which is exactly what the blanking plug does.

 

You just need to crimp some small electrical pins onto one 2" length of wire and the same on a 3" length and bridge some terminals 1&2 and 3&5 .

 

I am sure you are very capable of doing this to your own bike but not everyone is, a badly connected wire or wrongly connected wire can unfold a bigger problem in making it more expensive to fix or causing unreliability issues later.

 

http://www.datatool.co.uk/PDF/discondatatool/System21-UserGuide.pdf page 1, 3, 9.

 

OK if you are not happy to do this yourself that's fine and I think £100 for someone to come out to you and remove alarm is not on the expensive side, If you have told insurance that you have a alarm it will be a good idea to tell them it is not in place now along with any other modification you have done or intending to do in the near future, I did lots of alterations to my bike and even the notified them about bar end mirrors all at the same time only charged me £35 admin charge only to update my insurance a big peace of mind.

 

Adam, Don't forget the remap you had as well, you really need to start enjoying what you spent on the bike now.

 

You just need a few more days like that one without any more bike problems.

 

He's not using one of these is he?

 

I hope you have more luck than me, just been to Ed Triumph and got the 'other' plug, it dont fit!!!!
They say there are only 2, tried both, any one know better?
POXY ALARMS!!!

 

Is your alarm datatool 2 or 3