Data tool alarm problems

If yours is the same as the one I had on my T100, there's a button on the front of the remote and another on the back - and with a combination of button presses you can turn the alarm off completely.

 

.................or get the plug and totally dis-connect it.
There are 2 types of plug, so let your Triumph dealer tell them which one you need.

 

Try this press both buttons for approx 10 secs with ignition on until you hear a beep switch ignition off this should shut alarm down.

 

that puts it into winter mode with just the immobiliser on, remember it resets when you turn the ignition back on so when you put her a way again you will have to repeat the process

 

Crispey is right but if this does not silence your alarm you may have a alarm fault you then might have to purchase a shorting plug as HO recommends.have you got a operators guide for alarm fitted ??

 

I

Is the led on or off when you disarm alarm

 

So alarm led off and alarm is sounding ??

 

Possibly the bike battery is discharging itself due to a shorted cell, when it reaches the low voltage threshold to set the alarm off, the alarm sounds. So you start the bike and recharge the battery and the problem goes away until next time it's left long enough to drop again.

 

So alarm sounds when engine is running and led is showing that it is armed ?

 

Get rid of it, I stripped my Datatool 3 out yesterday and riding the bike today without any shenanigans was such a relief. Incidentally you don't need a blanking plug , just two wire loops bridging specific terminals.

 

I would not go cutting the bike wiring and bridging cables unless you are 100% ok with doing this to your bikes wiring a factory fit shorting plug costs about £5.00 from Triumph dealership and will put bike back to pre-alarm condition.

 

sorry i read it that alarm was going off while riding best put it in service mode and count flashes of led to see what is triggering it then.