Jacking Up A Thunderbird

Interesting Zoso thanks for sharing like myself your not convinced about lifting the full weight of the bike on the sump

So you went and lifted the full weight of the bike on the sump with a piece of chipboard as protection

But you didnt keep it there long term but lifted the full weight on the sump again to lower it

You still haven't convinced me its a good idea, but guess you have proved it may be ok done quickly

Cheers Zoso - I think (but maybe only briefly )

 

Sorry newbie from US.

I recently had same issue when trying to install Triumph driving lights and needed to remove front wheel. I too was not comfortable jacking with pressure on the sump.

Not promoting a product, just a solution. A guy here in the US produces custom "jack brackets" called Jack-be-quick. They remain on the bike, look like part of the frame and give you front and rear jack points. Instructions were spot-on and fit was perfect. He makes for Thunderbird with and with a cat.

http://jack-be-quick.com/

NOTE: You still need a fairly low profile jack.

I can send photos tonight when I get home if you need to see them.

PS for those superstitious people it also gave me a place to hang my "gremlin bell".

 

Welcome in KevinK , yep seen the jack be quicks look like a good option for jacking either end.

 

Will try to post pictures tonight (Eastern US time) so you can see.

 

Walked out to parking garage at work.

First, Triumphs rule today!
Second, sorry for dirt in pics; live off gravel road and TBird did not have weekly bath yet.

FrontBracketTop show how it uses Engine mount bolt.
RearBracketTop show how it uses the Passenger board/peg mounting holes.

Hope pictures help (not professional quality).

 

FRONT BRACKET


FRONT AND REAR JACK - BE - QUICK
REAR BRACKET

 

Sorry to give you the wrong impression Zoso But unlike KevinK's my pics were cut and pasted from internet,
I dont have the lifting jack be quick's fitted but I reckon they definitely serve a purpose.

 

Just found this forum after years on the RAT forum & Thunderbird1600 forum.
To be out in the open right away, I am Jack-Be-Quick. It's always good to see posative feedback on my products, whether cat delete elbows, handlebar spacers or lifting brackets. I'll attach some more pics of the JBQ installed.
The HP (LT & Commander) & NC (TBird/Storm) fit 1.75" (45MM) higher in the frame than the STD model, virtually out of sight.
I see that most of the members are from the UK. Most of the time, two kits can be shipped together a lot cheaper than two individuals, so if two owners live close enough, that would save you some.
Look forward to being a part of the forum.
Bob

 

I bought one 2 yrs ago and only just getting chance to fit it. I don’t think the original bolts for my rear foot boards are long enough do you happen to know what size bolts they would be?

 

Did you get the black or the chromium bolts?
Black ones started to rust, so were superseded by the chromium.
If you have floor boards, you'll want all M10-1.25X50
https://www.ebay.com/itm/222627190529

 

I’ll take a picture of everything I received later when I go to workshop if I can impose?

 

This is all that I received however a neighbour did unpack it while I was away and he swears it’s all that was there. No instructions apparently

 

You apparently have an LT or Commander. That's all you need. The 40 MM chromium bolts will be (barely) adequate with the floor boards, but you'd be better with the 50 MM bolts there as well.

 

Thank you I will take your advice and fit 50mm probably hex key (Allen key) regards Tim