Hiding Wires When Installing New Indicators

Ok im not sure if this is the correct forum but i have some new indicators to fit on the rear of my bonne. Im either going with the shock mounts or the under seat mounts however i don't like the cables being on show. It feels a little unfinished even though the wires have a shroud protecting them from water. I was wondering if anyone knows where i can get some tapered rubber hosing to fit over the indicator thread and also over the wire shroud.

 

hi, you can get some heat shrink tubing one size for the for the cabling and larger for the indicator thread. or try amalgamating tape

 

Yep shrink wrap will do it

 

I used heat shrink on mine and it covered the threads and the cables.

 

Another heat shrink did the job for me.

 

Heat shrink the cable/threaded end to stop any water ingress, then just push some of this over the cable to hide completely....

http://www.ebay.co.uk/itm/Silicone-...ber-Air-Water-Coolant-Oil-Turbo-/191234806480

 

Cheaper again if you pinch it from work
Hee hee