Featured Few Jobs Done Today

Wanted to get a few hard to reach places cleaned today, I stripped the sub frame apart when I got it to clean that up last year. Also did an oil and filter change as not had one since 2015 but only done 4,500 since, think I've put about 1,200 miles on it.
Untitled by Bryan Haynes, on Flickr
Removed the rear hugger to give inside a proper wash and polish, took off chain guard to give that a proper clean up to get old chain lube of too. I decided to pull rear caliper off to clean and check pads, found a stuck piston, cleaned and lubed all the pins too while it was off. Has had new pads a little while b4 I got it as hardly worn.
Gave rear wheel a wash and polish b4 refitting.
Untitled by Bryan Haynes, on Flickr

 

It is a nice feeling to bond with the loved ones!

 

Nice job sir, but that poor bike is crying to be ridden more.

 

I was going out on it but it rained here Friday night and I decided not to set alarm as was going to be early meet and I was working till nearly 4am. But it brightened up a bit so I thought I would get there jobs done as my friends would be about 100 miles away.
Just checked and I've done over 2,000 miles on it in the 9 months I've owned it, still not enough though, sorry.

 

Well you’ll have lots of time this year hopefully

 

Seeing you'd gone that far shame you didn't strip and grease the hub eccentric and suspension linkage.
.....But you can't beat a good clean.....may be next time.

 

need to get an ABBA stand to do that, going to get one so i can do it and the linkage bearings,

 

I need to that on mine