Separate names with a comma.
Hi Martyn, yes it is and it has 5 months tax on it now. Regards Simon
Thanks Aidie, yes it looks and rides well. Can't be many in this condition left. The day I finished it a guy made me a much higher offer at the...
Had one time waster but now SOLD to new owner. Triumph Tiger 885 carb (aka Steamer) in very good condition. Body work and mechanical restoration...
Hi all, anyone had trouble with the seal between the fuel tap and the fuel tank. I bought a new fuel tap which came with a new seal but fuel has...
I have these carbs and I think the screw is item 12 so does that help with whether it is in or out to lean the mixture....
Greetings, bike running fine following carb rebuild but slight smell of fuel so suspect running rich. Can you remind me how to lean with the...
Hi, I didn’t know that. Do the readings look ok? I had the valves checked and adjusted along with a compression check which was also good. I know...
Hi Colin, a fellow Steamer owner, not far from you and always in the Peaks. I tinker with mine too so let me know how you get on. Just spent weeks...
Three hours later.....set mixture screws to 2 1/4 turns and found I hadn't tightened the rubber seal between the engine and carb on number...
Going to try 2 1/4 turns and then 2 turns on the mixture screw before I start moving needles up/down. Trouble is I cannot get to the mixture...
Had new plugs in the summer. It’s pulling hard now... was awful at low revs before I put 2 1/2 turns on the mixture screw
Need some more help guys. 94 Tiger Mikuni carbs back on, bike starts and idles but poor power at low revs . I thought it might be mixture so gave...
I agree...a lot of people I know thought that leaving would mean we go our own way on rules/regs/law but obs that won't be the case....anyway...
OK going to get controversial. What a stupid idea. Good job we are leaving then but I suspect when we are out we will have to adopt all their...
Purchased a damaged tank then spent some time putting right a bodged repair made by a previous owner and then fuel proofing the tank with some...
Hi Joe, I assume the nunbers don't really matter so long as they are all the same on each gauge ? [ATTACH]
Does anyone know what number of turns out the mixture screws are set to when they come out of the factory ? My carbs were 1 3/4 turn out but I'm...
Thanks, I will let him know
Can't play but my dad is Gordon Giltrap :)
Hi Joe, took your advice and went for the Carbtune 4 col :) Thanks for the comments everyone