Atrermarket Can/Exhaust Bolt On

Looking to see what you have lying around
Im after a bolt on can, the sort that are used on the Daytona600/650 - TT600 - '02 Street3's - ZX6r

My current stubby is attracting too much attention

 

I got a spare carbon can, not a stubby but its not really going to quieten it down. Its off a d600.

 

still interested :upyeah:
got any piccies and how much are you looking for it ?

 

Sent a pm mate

 

Ive got an empty baked bean can.... Hope that helps! :tongue:

 

cheap one on Ebay Triumph TT600 Exhaust Can (Black) | eBay

 

Easily covered in satin carbon, or can (pun) get it sprayed chrome.

 

Conquest Carbon is the man for carbon fibre & i believe he has a brother called Conquest Chrome too.....

 

Thanks for the offer but I fear that it might be a slip on where I really need a bolt on can.
The fleabay link is for a standard daytona 650 can

Looking forward to SpankyHam's piccie if he gets chance :biggrin:

 

Haven't been down to the garage yet spudda will get some over the weekend mate

 

No worries mate

to get down to his garage is what I meant to say

 

Ha ha no probs mate don't worry, the garage is down the road hence my laziness getting some pics!

 

Which at £30 you could cut down and remove baffles. Checked and end is riveted on so simple.... That and there were loads on eBay of various types...

 

Could you not cut off the bolt-on flange on header/link pipe & then use a slip on?

 

Thanks Screwball but thats not a route I want to go down. It looks naff
Its like asking you to bend and shape your OEM to make it look like your GPR .... yeah it'll work but :frown:

its been done before but the od is 58mm dia and most slip ons are 50mm .... you need to fabricate a slip connector which looks untidy

 

Think a straight cut is a bit different to a taper and multiple welds but know what your saying.... Seen plenty cut down as they try And replicate the stumpy look... Even high end exhausts.... Still loads on Fleebay to choose from... All depends on how deep are your pockets...

 

the GPR on yours follows the lines nicely ...

tighter than a gnats chuff :wink:

 

:biggrin::biggrin:

 

Here you go, currently taken apart for repacking but will assemble it all back up if you wanted it. It has two nuts on the top to screw to the rear pegs and hang it and it has a bracket included just in case you remove the rear footpegs. Tiz what it is really, was going to hack it up and stubby it myself.

 

Spanky looks good...