Hand Guards For A Speed Twin

I am looking for some hand guards to fit the 2023 Speed Twin 900. I tried the Oxford product and while they are good I couldn't fit them into the bar end as the ST has Triumph fitted heated grips - which seems to prevent the Oxford ones from fitting. Has anyone had any success sourcing any handguards that will fit the ST? Thanks.

 

I did but I may have another look. The problem I had with the Oxford ones was the fitting to the existing Triumph Heated Grips - see below. Not sure the same issue will occur with the BB products. BB are good but pricey.

 

To fit them relied on inserting a locking flange into the existing grips using a specific bolt. They do not clamp round the bar end nor the handlebars. The Triumph stock heated grips fitted to the bike prevented this fitting being used and therefore I had to return the Oxford handguards. This was a pity as I liked the Oxford design. With hindsight I wouldn't have fitted the heated grips and stuck with heated gloves and the Oxford handguards. Although the heated grips are nice, the fingers do get cold - especially when at speed on the motorway. Hence the option to fit guards to deflect wind and rain.

 

Thanks for the comprehensive reply. Yes I did think of using the existing factory bolt however removing the in place bolt and locking mechanism on the Oxford guard bracket was too difficult and therefore couldn't be replaced. I agree finding a solution that clamps around the bar end OR some other part of the handlebar is probably the answer and it is possible that BB provide such a solution - but they are pricey. Another option has emerged, a friend has a 3D printer and has found a design to download off the web. It clamps around the bar end. It may actually work. I wasn't looking for something permanent - just to fit in the winter months for the occasional ride. The 3d print jobs would be cheap and easily replaceable when or if broken.