Squeaking brakes.

My advice would be -
First remove brake pads, give them general clean and de glaze pads and disc with a bit sandpaper, (rub lightly pad face and disc, could also use spray brake cleaner)
then apply a slight smear of copper slip/ paste to rear of brake pad or to the anti squeal plate should
one be fixed to pad rear, (do not get it on pad surface or disc) re-assemble and all should be ok,
do this as part of your brake service each time.

 

Agree with TEZ217 - copper grease is wonderful stuff!

 

Its very easy Sam !!! but I would suggest you buy yourself a Haynes manual first,
( around 20 quid see ebay) it will guide you through each step and give you pictures
as a reference throughout,
Take it easy one step at a time and I'm sure you'll be ok, that's how we all learnt

 

Ha Ha thats the one Sam, - So first off kettle on make a coffee have a good read, sit by your bike so you can cross reference photo's and instructions as you read through the procedure, plan you job out !!! buy your bits in wet and dry paper copper slip etc and go for it, take your first step into home maintenance on your bike and enjoy
"So less nights down the local instead study your manual Sam."

 

I would be worried about my bits being in wet and dry paper!

 

It Means - BUY IN YOUR BITS AND PIECES READY FOR THE TASK AHEAD
( the parts needed to complete your brake job)

wet and dry paper is just a form of sand paper available in any car auto parts shop
(that can be used wet or dry) in your case use it dry, wetting it is normally used to rub down bodywork etc before painting.

Copper slip - as shown in picture thanks to Steve Lovatt.

Sorry Sam just the way I wrote it, - hence the piss take comments above

 

Also have a look at you tube videos of people removing brake pads on similar bikes so that you can familiarise yourself with the process. Delboys or similar would do

 

A small amount to the back of the pads where the piston touches and any other part of the pad that rubs against the caliper - just make sure none of it gets on the pad itself.

 

If your passing through Dumfries & Galloway at any time, I'll sort it for you