Featured Rocket Something For Cerberus Part Two

NOT THE WAY I MAKEM - There ya go marra FTFY,

Looking at that lot marra there gan naewhere, weld heat aint ganna move them till fixed

 

Come on Dilli, should be easy enough.

I’m sure the BIG BMW’s have some sort of power assisted centre stand, I saw one in operation whilst in Peel IOM.

Now I’m sure that if Jerry can make one work then the best of British can.

 

@dilligaf come on mate we don’t have to get Herr @littleade and the Camp Kommandant @Winglad on the case do we

 

In German, a center-stand is called ‚Mittelständer‘, while a ‚Ständer‘ is also a hard-on.
So, the latter is hydraulically operated, right?
Let the Thommies take over from here, don’t you agree, Herr @littleade ?

 

In Scots too

 

Would that be equal to ‚Stoner‘?

 

You need a hydraulic lift table mate

 

Stand-er.

 

What power setting are you on should be around 3/4 for that I would have thought

 

Dilli if your concerned about blowing holes then make and break weld on the high setting.

 

Have another practice on high and move the torch more quickly you need the heat to penetrate through to the back

 

@dilligaf, Looking at your earlier tidy garage pictures it looked like your main fuse/consumer board was in the garage ? if it is its very easy to run some garage sockets direct from it, thus keeping back door shut and wife happy at the same time.

 

Just had another look at your previous thread pictures regards electric consumer box, looks a good age is that still Fuse wire or cartridge fuse ?
Have you another in the house itself ?